Position throttle arm slot to face stop harness exit barrel to tube with allen screw approximately hole in tiller handle. Minimum pressure should be 500 P. Check that plug-in connectors are fully engaged. Your will receive a download link immediately after your payment is completed. In order to perform the work efficiently and to avoid costly mistakes, read the text and thoroughly familiarise yourself with procedures before starting work.
Open valve d and close valve e. Remove tilt rod and cap. A basic knowledge of mechanics, including the proper use of tools and workshop procedures is necessary in order to carry out maintenance and repair work, satisfactorily. Replace armature if a short is indicated. Both overheat and low oil conditions are monitored by a warning module mounted on the starboard side of the engine block. Quicksilver 2-Cycle Outboard Oil is recom- mended for this oil injection system.
Any de- bris in power trim system can cause system to malfunction. Comprehensive explanations of all installation, removal, disassembly, assembly, repair and check procedures are laid out with the individual steps in sequential order. Use an ohmmeter R x 1000 scale and perform the following test. Reinstall Flywheel, washer and nut. Remove at terminal block on engine when key or choke lower hose from fitting on enrichener valve. Use an ohmmeter and perform the following test.
Remove two screws to remove pump. Open manual release valve three turns maxi- mum counterclockwise and position trim rod to full up position. This manual includes special notes, important points, service data, precautions, etc. Inspect bushings and replace if worn. These are the actual factory issues! Install a flat ring if equipped into groove in each end cap. Install bearing carrier and propeller shaft into must be between specification shown in chart. The Audi R8 Spyder 4.
Drive Shaft Long Drive Shaft X-Long Shim Bearing Race Tapered Bearing Washer Screw Washer Screw Washer Screw Magnetic Pinion Nut 94. Place trim rod assembly on clean work surface. Place shim s retained from disassembly into Hammer 91-34569A1. Drive pin in until flush. Remove Rear Cowl Mounting Bracket from pow- 8. Replace upper drive shaft bearing and sleeve if and corresponding bearing. Replace cam follower if worn or pitted.
Position engines so that they are facing straight forward. Install 2 rubber collars and 2 rubber bumpers. Allow a 2 minute cooling nents: period between starting attempts. Install tensioner spring and tighten timing belt tensioner. Torque screws to 70 lb. S Install fuel bowl gasket. Check shift operation as follows: splines will not align with the crankshaft splines, place a.
Install throttle arm assembly into tiller arm. Retract throttle cable into gear assembly until assembly. Protect lip on front side of bearing carrier using bricate outside diameter of bearing with a light Bearing Installation Tool 91-13945. N·m Exhaust Plate Dowel Pin Lower Cowl Seal Upper Mount Bolt — Upper Mount to Exhaust Plate 31. Place shift lever in forward gear. Avoid dropping electrolyte on boat or clothing, as Specific Gravity Readings it is extremely corrosive.
Remove hoses to fuel pump and oil injection pump. Boss Magnum, Twin Drag, 6:1 Retrieve. Remove shift arm linkage at stud. Check all fuel line con- nections for tightness. Insert retainer thru plastic disc and rubber check valve. Connect Voltmeter red lead to Point 3, D Replace fuse. Powerhead Reassembly and There should be no preload pressure between reed Installation and reed-block , but a slight preload is tolerable.
Install cylinder head cover and driven sprockets. Carefully inspect carburetor body and fuel bowl S Install low speed mixture screw. S Inspect crankshaft to drive shaft splines for wear. Slide cover and friction device onto throttle arm. Model 100 Model 115 Horsepower 100 74.