If you have all of your paperwork from the alarm system there should be a book that can help walk you through the reprogramming mode. The car still starts and runs properly? Power will turn off to save the battery This warning appears in message area of the vehicle information display after a period of time if the shift lever has not moved from the P Park position. The locksmith only reprogrammed the keys to make the door locks and windows work. I agree, however, that the vehicle will likely have to be taken to a Nissan or Infiniti dealer to have the keys initialized to the control unit. My 2009 Altima was beast. I know it's not the key fob's battery as the car will tell you when the key fob's battery is low. Upon starting the car was taken to the dealership.
Engine start operation for Intelligent Key system if I-Key battery is low if so equipped This indicator appears when the battery of the Intelligent Key is low and when the Intelligent Key system and the vehicle are not communicating normally. Remote Start if so equipped 22. If this indicator illuminates, replace the battery with a new one. Stop Vehicle if so equipped This warning may appear while trying to free a stuck vehicle due to increased oil temperature. There are a few other things worth noting: 1.
I've noticed that with mine sometimes it will act like there is no key, especially if I have the keys buried in a coat pocket and I manage to really bury it. It gives no warning, and it goes back to running normal as if nothing has ever happened. May be from friends or family member. The vehicle was not repaired. This is for security purposes and should not be cause for alarm. This is an electrical system ignition flaw and we're extremely concerned about the safety of this vehicle and of being stranded.
Yet - it worked fine for 2. Communication problems may be one of the reasons that the warning light turns on. I have not taken the car to Nissan yet to get it repaired, because honestly I can not afford to pay 100 dollars an hour to have the car sit on the machine to test it, then how ever much it is to fix the problem, which could run into thousands of dollars. One of the most common causes of failure is inappropriate handling during wheel or tire removal or servicing. Description The accelerator pedal position sensor is installed on the upper end of the accelerator pedal assembly. I have a clifford alarm which is still a viper.
I did try both keys, one at a time, and with the proximity ring for power. Jeep computers used to do that all the time over the gas cap. Do you keep the key in your pocket all the time? This was a salvage vehicle that we are fixing up. I tried to reset by disconnecting the battery but did not do anything. That way you know the issue from personal experience.
Electronics is difficult to troubleshoot. According to the manual the key must be with you inside in order for the vehicle to start. The low oil pressure warning is not designed to indicate a low oil level. Maybe pull the 12 volt and see if it resets the error codes? Ken Your car has a built in anti-theft system. They reported to me that this is very common, and the cam sensor is now repaired in a newly designed distributor, but all the original cam sensors in the factory distributors were experiencing a high failure rate. Make sure the Intelligent Key is inside the vehicle.
Tire Pressure Low - Add Air warning if so equipped This warning appears when the low tire pressure warning light in the meter illuminates and low tire pressure is detected. Sometimes vehicles are damaged on the lot or during delivery or even shortly after purchase. The contact stated that the automatic push-to-start ignition would not operate when engaged. The contact stated that the vehicle was equipped with a keyless ignition. The contact believed that the design posed a safety hazard. They had to start from scratch. If cruise control is on and cancelled, the speed will be displayed to show the speed the vehicle will return to if the resume button his activated.
It has a piece of mylar between the layers of cloth. Waited 15-20 minutes and then it started right up. If the light comes on while the engine is running, you can drive the vehicle. Door Open This warning illuminates when a door has been opened when the engine is running. I didn't remember that being lit before, so I looked it up.